V2000-c Rfid Access Control User Manual -

Press [2] + [Time in seconds (00-99)] + [#] (e.g., 05 for 5 seconds). Set Access Mode: Card or PIN (Default): Press [4] + [0] + [#] . Card and PIN: Press [4] + [1] + [#] . 5. Resetting to Factory Defaults

| Problem | Likely cause | Solution | |---------|--------------|----------| | No power | Wrong voltage | Check 12V DC, min 1A | | Card not beeping | Wrong RFID frequency | Use correct card type (125kHz EM) | | Green LED but lock doesn’t open | Relay wiring wrong | Check NO/COM or NC/COM based on lock type | | Buzzer long beep after card | User not enrolled | Add user via programming | | Door open too long alarm | Door contact stuck | Adjust sensor position or disable with 04 0# | V2000-c Rfid Access Control User Manual

The V2000-C RFID access control system is a cutting-edge solution designed to control access to a specific area or premises. The system uses RFID technology to identify and authenticate individuals with authorized access. The system consists of a control panel, RFID readers, and electronic locks. Press [2] + [Time in seconds (00-99)] + [#] (e

| Problem | Probable Cause | Solution (per manual) | | :--- | :--- | :--- | | No power on keypad | Blown fuse or low voltage | Check 12V adapter; replace 1A fuse | | Card not reading | Wrong frequency card | Use supplied 125kHz card | | Door stays locked | Exit button wired NC/NO incorrectly | Swap NO/COM on PUSH terminal | | Master code forgotten | Memory corruption | Open case; short RST for 10s (resets to 123456) | The system consists of a control panel, RFID

V2000-C Standalone access controller system for single door access