The router will automatically restart once the installation is complete.
If your internet is working fine, it is often better to leave the firmware alone . The risk of "bricking" the HG658 V2 during a manual flash—especially with custom ISP firmware—is often higher than the benefit of the update itself. Hg658 V2 Home Gateway Firmware Update
| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | You downloaded firmware for HG658 (non-V2) or a different region. | Double-check the hardware version. Redownload from ISP. | | Update freezes at 50% | Corrupted file or unstable connection. | Do not reset. Wait 30 min. If stuck, power cycle (risky but necessary). Then revert to old firmware. | | Router won’t boot after update (all LEDs dark or flashing Power) | Bricked. Bootloader may be intact. | Emergency recovery: Hold the reset button for 30 seconds while powering on. Then use TFTP recovery (advanced users). | | WiFi slower after update | Settings were wiped; WiFi channel congestion. | Log in, change WiFi channel to 1, 6, or 11 (2.4GHz). Enable 5GHz if available. | | Can’t connect to internet | ISP VLAN or PPPoE credentials lost. | Re-enter your username/password from your ISP’s welcome email. | The router will automatically restart once the installation