Bnd-50 Se36 Instructions ((install)) Site

| Register Address | Description | |------------------|-------------| | 0x0000 | Digital inputs (bits 0-23) | | 0x0001 | Digital outputs (bits 0-19) | | 0x0064 | Analog input AI0 (scaled 0-4095) | | 0x0065 | Analog input AI1 | | 0x00C8 | Analog output AO0 (write 0-4095) |

| Tool | Specification | |------|----------------| | Welder | MIG or TIG (steel, 0.030" wire) | | Angle grinder | With flap disc & cutoff wheel | | Drill | 12mm cobalt bit | | Punch set | Center punch | | Floor jack & jack stands | 3-ton min | | E36 rear subframe bushing tool | Or press | | Torque wrench | 20–150 Nm range | | Paint/primer | Rust-preventative (e.g., epoxy or zinc primer) | | Safety gear | Welding helmet, gloves, ear/eye protection | bnd-50 se36 instructions

Before programming, the internal Ni-MH battery may need a charge. Plug the unit into a live outlet for a few hours if the display is blank. : ear/eye protection | Before programming

With that info, I can better guide you to a manual or explain how to interpret the markings. bnd-50 se36 instructions